![]() ![]() ![]() In my recordings, I use a mix of Neural VSTs and Axe-FX re-amping. VSTs simply aren't a very good playing experience, but good ones (and Neural ones are mostly very good) offer a way to get great guitar sounds in your mixes more easily, once you've recorded a basic guitar input tone. I just see amp VSTs as fulfilling a different purpose than modeling amps. Honestly, it probably has a better DAC in it than the Audient does.Ĭlick to expand.I wouldn't be so quick to write off the Neural. The easiest way to do this with the Kemper might be to use it as your audio interface, rather than the Audient. You can then take your pick of how to reamp it-through the Kemper, if you want, or through amp VSTs. ![]() The key is to record only the Kemper's input signal, bypassing all its internal modeling and effects. You should be able to do this same thing with the Kemper. I then reamp the recording of the input signal through a VST (usually Neural) while I'm mixing or tracking other instruments. Since my AFX plugs directly into my monitors, I'm thus bypassing the PC altogether for monitoring purposes. While recording, I monitor using the internal AFX2 sounds rather than a VST. Instead, I use my Axe-FX 2 as my guitar interface, recording only the input signal. Latency is always a problem, and I never get the right feel. In all honesty, I never play from my Scarlett interface directly into a VST. Not enough so that latency becomes a problem, but enough to create a bigger buffer. Try setting the buffer in the Neural plugin a little higher. Sorry if this is an obvious question, I just have little to no experience with this.Ĭould be a buffering issue. I set the DI gain so that it doesn't clip, but the output seems to be clipping a little bit.ĭoes anyone have any ideas on why I'm getting the extra noise, and why the tone sounds distant and muffled? I don't have monitors plugged in, just the headphones out the headphone output at the front of the interface. Signal is - Guitar > Mogami 3ft cable > D.I input of Audient iD4 > USB cable to PC running Windows (i5, 16GB DDR3). So far the noise doesn't occur when using my Kemper either. This issue isn't present when I'm just listening to music, or watching video, but only appears in the plug in software. The only issue I'm having is that when I tried the Neural DSP plug in for quiet recording at night, the sound was relatively muffled, with some audible pops and crackling. since you now have an extra set of hands.I received my first proper audio interface yesterday (Audient iD4) along with some Beyerdynamic DT770 pro headphones and really like the build quality and feel of them. This is also a great trick to try out new mics, mic positions, etc. Hit record on the new track, and voila, you're re-amping the track. Instrument cable from RMP to pedalboard/ampĪdd new audio track with cab microphone as input ![]() Remember, it doesn't remember what output channel you set it to as long as it's going to the device you're using to re-amp the signal into your guitar amp. If you like, run a DI before any effects or the amp so that when you record, you always get the mic'd amp and a DI signal with that take's performance.Ĭhange the output destination on the DI'd guitar track from Main to Reamp so that there's no guitar signal - it goes out to the reamp (I use Radial's Pro RMP). The best sounds for re-amping will be clean, either clean guitar amp or DI. In Pro Tools, your input and output channels aren't linked you can rename them whatever you want. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |